Modelling the cooker

These images below are the images of cookers I used as reference for the cooker I modelled in my scene.

To model the cooker, I started off with a box and I inset the front face and extruded it inwards. Then for the panel with the dials, floor and the bottom panel, I used separate boxes to and placed them just slightly off main box to create the gap as seen in the references between the panels and door and the main body.

To create the stoves, I inset the top and extruded it inwards then chamfered the corners. I then added 2 lines in the middle and extruded that face upwards to create the solid part in the centre. I then used the line tool to create the out line of the stove and used the fillet to round off the edges and then turned it to and editable ply, extruded it then inset the top and bottom faces and bridged them together. I used the line tool again to create the bars on the stove that the pans sit on.

To create the knobs on the front of the cooker, I used a cylinder and scaled in the front part then and then inset that face and extruded inwards. I then used an sphere and placed it in the cylinder where I had extruded in inwards then I create a box and added lines going across and attached it to the knob to create the dial on the knob.

The handle was created from a line tool where I used Bezier corner to create the curve.